SewHQ: Your Friendly Online Sewing Club

Access 1,000+ sewing patterns and join our community
START FOR £1

NO COMMITMENTS. CANCEL ANYTIME

Home   Sewing Patterns   Vintage Sewing Set
Vintage Sewing Set
Vintage Sewing Set
Vintage Sewing Set
Vintage Sewing Set
Vintage Sewing Set
Vintage Sewing Set

Vintage Sewing Set

Designer
Designer
Amanda Walker
Pattern Guide
Pattern Guide
Download
Designer
Designer
Amanda Walker
Pattern Guide
Pattern Guide
Download

Share this  

Safety Notice: Handmade items made from this pattern may contain small parts or long cords that pose choking or strangulation risks. Not suitable for children under 3 years. Please see the full safety disclaimer at sewmag.co.uk/safety.

About this pattern

Essentials

  • Fabric: Tilda, mini spot, red: mille, teal
  • Ribbon, linen, heart print
  • Felt flowers, cream
  • Buttons, pink
  • Wadding
  • Paper flowers
  • Thread: embroidery, machine

    To unlock all the content, Join SewHQ

    Pin cushion

    1. Cut out four 8cm squares from spotty and floral fabric, then stitch them together in matching pairs using a 1cm seam allowance, so there are four sets. Join two of the assembled squares together, making sure that a spotty piece is attached to a floral one and repeat.

    2. With the right sides of the fabric facing, lay one assembled square on top of the other, matching the seams. Sew around the borders of the square and leave a small gap along one edge. Trim away any bulk and turn it out. Tease the corners and seams, then press.

    3. Cut two squares of wadding to the size of the patchwork and fit inside, making sure that the corners are filled, then slip-stitch the gap closed. Wrap a length of heart linen ribbon around it, overlap the ends and secure. Repeat the process in the opposite direction.

    4. Layer a paper flower on top of a felt one, together with a button. Sew the assembled flower over the ribbon in the centre of the cushion, working through all the layers and pulling the threads tight. Wrap a length of ribbon underneath the flower and tie in a bow to finish.

    Scissor case

    1. Cut spotty fabric, 10cm x 46cm, and a floral piece, 10cm x 24cm. Fold the floral rectangle in half, then lay to match the shorter base of the spotty rectangle. Position a 10cm length of ribbon above the folded edge of the floral, then fold the top of the spotty rectangle over and down to meet the 10cm base.

    2. Pin through all the layers, then stitch down each side with a 1cm seam allowance. Turn out through the base, tease the two top corners and the seams, then press. Turn the base of the floral and the spotty rectangle up, then stitch across the base, through all the layers. Trim away the corners and push back down to make a pocket for the case. Push out the corners and press.

    3. Fold the spotty top of the case down and place under the ribbon. Layer the paper flower on top of the fabric one and add a pink button. Sew this to the centre at the base of the spotty flap. Finally, cut a length of cord, tie in a bow and stitch to the middle of the heart ribbon.

    Needle wrap

You might also like these patterns