Sew a go-to shirt

1 Download and print the pattern, above. Interface the reverse of one collar and one collar band. Stitch the collars, right sides together, along outer edges. Clip corners, trim, turn right side out, and press. Turn lower edge of collar band (without interfacing) up. Press by 1.5cm. Match centre back raw edges, sandwich collar between bands, pin and stitch.

2 Trim the collar piece, turn right side out and press. Make a pleat at the upper edge of the back panel by bringing the notch nearest the side seam to the centre back on the left-hand side. Repeat for the right-hand side, forming an inverted pleat, and pin. Stitch across the upper edge within the seam allowance to hold in place.

3 Interface the reverse of the front facings and press the seam allowance in on the un-notched edges. Place right side up, with the raw edges and notches matched underneath the shirt front. Pin and stitch, bring the facing to the front and press. Pin the facing to the front panel, then topstitch both edges of the front facing close to the edge.

4 Join the back yoke to the lower back and front shoulders. Neaten the edges. Staystitch the neck edge slightly, within the seam allowance. Match the collar back centrally to the back neck edge. Pin right sides together (the edge with the pressed seam allowance should be inside the shirt).

5 Stitch and press the seam inside the collar band and tack the loose edge of the collar band to the shirt. From the right side of the shirt, topstitch the collar band, removing the tacking. Prepare the sleeves. Press a 1.5cm double turned hem at the wrist edge, leaving it unstitched at this stage.

6 Match the centre notch on the sleeve head to the shoulder seam and pin the sleeves to the armhole, easing slightly to fit. Stitch, neaten the edges and press seam towards sleeve. With right sides together and seams matched, join the side seams from the sleeve end (opening out pressed hem) to lower hem.